Manual

6
2c-3
INSTALL PROJECTOR BODY (EXTENSION PIPE)
Run the wiring through the pipe and through the JR3 body.
Ejecute el cable a través del tubo ya través del cuerpo JR3.
Exécuter le câblage à travers le tube et à travers le corps JR3.
Screen
Slide the universal plate into the JR3 body from right to left (while facing screen). Hold
the wires up to prevent interference.
Deslizar la placa universal en el cuerpo JR3 de derecha a izquierda (mientras se
enfrenta a la pantalla). Mantenga los cables para prevenir interferencias.
Glisser la plaque universelle dans le corps JR3 de droite à gauche (en faisant face
écran). Maintenir les ls en place pour éviter les interférences.
3-1
INSTALL PROJECTOR
Screen
Tighten pre-installed thumb screw and attach at least one of two retaining screws (F)
on the opposite side of the housing.
Apretar pre-instalado tornillo de mariposa y adjuntar al menos uno de los dos tornil-
los de jación (F) En el lado opuesto de la carcasa.
Serrer la vis à oreilles pré-installé et xer au moins une des deux vis de xation (F) Sur
le côté opposé du boîtier.
3-2
INSTALL PROJECTOR
(F)
(K)
Screen
JR3-0002