Troubleshooting guide

Minimum Grip Setup (High Grip Track)

The following settings are recommended as a starting point for a dry track with a high amount

of grip, perhaps one with a lot of rubber laid down. The attempt here is to lose grip from the

kart. The following recommendations should aid in this.

Weight distribution should be 43.0” front, 57%.0 rear and 50/50% side to side.

Toe should be set out to 1/16”-1/8” on each side.

Camber should be set at -1/2 degree (negative ½) to 0 degree

Caster should be at III/III settings. Try less caster as grip comes up, more as tires wear.

Front bumper should always be tight.

Front width should be 44” to 44-1/2”.

Side pod bars need to be loose

Seat should be set as low as possible.

Rear wheel hubs should be the shortest length (for minimum rear grip).

Rear ride height should be as low as possible (axle in highest position).

Rear track should start at 55” for minimum grip.

Axle should be soft.

Loosen or remove the seat struts.

Rear torsion bar should be removed.

Rear bumper should be tight.