Installation guide

Crestron V24-IMCW-C Interface Module for V24R-C and V24RL-C
Setup
Network Wiring
When wiring the DM
®
network, consider the following:
• Use Crestron
®
Certified Wire.
• Use Crestron power supplies for Crestron equipment.
• Provide sufficient power to the system.
• For DM 8G+ wiring, use Crestron DM-CBL-8G DigitalMedia
8G™ cable or generic CAT5e (or better) UTP or STP. Maximum
wire length for DM 8G+ is 330 feet (100 meters) between devices.
Shielded cable and connectors are recommended to safeguard
against unpredictable environmental electrical noise, which may
impact performance at resolutions above 1080p. All wire and
cables sold separately. Refer to the DigitalMedia™ Design Guide
(Doc. 4546) for complete system design guidelines.
NOTE: For optimum performance and ESD (electrostatic
discharge) protection, Crestron strongly recommends using
DM-CBL-8G cable.
Installation Guide – DOC. 7175C Interface Module: V24-IMCW-C • 7