Specifications

V-Panel Integrated 12” & 15” HD Touch ScreensCrestron TPMC-V12/V15
• Each device using IP to communicate with a control system must have a
unique IP ID.
V-Panel Configuration
NOTE: The only connection required to configure the touch screen is power. Refer
to “Hardware Hookup” on page 48 for details.
The TPMC-V12/15 is configured from the setup menu.
NOTE: If no project has been loaded or if an invalid project has been loaded, the
touch screen displays an error message and defaults to the setup menu screen.
If a project is running, the setup menu can be accessed using one of three methods:
1. Touch the screen during boot up when the “Preparing to Load Project”
message is visible. Maintain touch until after the countdown, when the
message changes to “Loading Setup Screen”.
2. If the project has a button defined for this purpose, touching the button
provides entry into the setup menu.
3. Crestron Toolbox can be also used to enter the setup menu:
a. Establish communication with the touch screen (refer to “Establishing
Communication” on page 51 for details).
b. Right-click on the device and select Functions > Setup Mode….
“Setup/Calibrate” Window
c. Select Enter Setup Mode. The setup menu opens as shown in the
following illustration.
NOTE: Select Exit Setup Mode to exit the setup menu.
28 • V-Panel Integrated 12” & 15” HD Touch Screens: TPMC-V12 & TPMC-V15 Operations Guide – DOC. 6940G