Specifications

Crestron UPX-2 Universal Presentation Processor
The Functions menu may now be used to upload a project, update
firmware, and reset the network ID.
Crestron Toolbox Functions Menu
TCP/IP Communication
This section explains how to configure a UPX-2 to communicate over Ethernet using
TCP/IP. These procedures assume that the UPX-2 has been powered up and
connected as shown on page 60.
1. To establish TCP/IP communications with the UPX-2, a serial connection
must be established between the PC and UPX-2. Refer to “Serial
Communication Setup” on page 60 for instructions.
2. While connected to the UPX-2, select Functions | Ethernet Addressing.
The current IP address, IP mask and default router are displayed.
“Ethernet Address” Window
3. Enter a new IP address, IP Mask, Default Router, or select Enable DHCP
and click OK.
64 ¥ Universal Presentation Processor: UPX-2 Operations Guide – DOC. 6276B