Specifications

Crestron UPX-2 Universal Presentation Processor
NOTE: The UPX-2’s calibration routine can also be accessed through Crestron
Toolbox by selecting the device from the Network Device Tree and right-clicking
the device to select Functions | Setup Mode…. Select Enter Calibration Mode to
begin calibration.
Click Detect to detect a new touch device.
Click Close to close the “Touch Device Configuration” window.
Press OK to accept the changes and return to the SETUP MENU.
Configuring Other Touchpanels
A variety of third party touchpanels and tablets are supported by the UPX-2. Click
Other Devices in the "Touch Screen/Console Settings" window to open the “Touch
Configuration” window for third party devices.
“Touch Configuration” Window
A device can be calibrated by selecting the device and clicking Calibrate. The
timeout (in seconds) for the calibration procedure can be adjusted from this screen by
clicking the up or down arrows next to the time value. To add a new device, click
Add… to open the “Configure Device” window.
If a device’s configuration requires changes to be made, select the device and click
Modify… to open the device’s “Configure Device” window.
NOTE: Only one third party touchpanel can be connected to the UPX-2 at a time.
Before adding a new third party touchpanel, the existing touchpanel entry must be
removed by clicking Remove….
32 ¥ Universal Presentation Processor: UPX-2 Operations Guide – DOC. 6276B