Specifications

Crestron Isys

TPS-4000 10.4 Inch Tilt Touchpanel

AUDIO Pinouts

TYPE PIN DESIGNATION DESCRIPTION

1 L+ Left Input (Positive)

2 L- Left Input (Negative)

3 GND/Shield Audio Input Ground/Shield

4 R+ Right Input (Positive)

5 R- Right Input (Negative)

6 GND/Shield Mic Output Ground/Shield

7 M+ Mic Output (Positive)

Front

Top

8 M- Mic Output (Negative)

To determine the location of pin 1, hold the supplied cable so that the end of the

8-pin RJ45 connector is facing away from you, with the clip side down and the

copper side up. The copper contact on the far left is pin 1.

NOTE: When connecting the touchpanel to the interface module, do not confuse the

8-pin audio cable with the 10-pin net/video cable.

RS-232

This 6-pin RJ-11 connector mates with a 9-pin serial port of a PC. The connecting

cable is not supplied. Use this port to establish a direct connection between the

touchpanel and a PC without a control system or network connection. Once the

direct connection is established, touchpanel files and firmware updates can be

uploaded to the touchpanel. Additionally, the touchpanel’s diagnostic tools can be

accessed over the direct connection. In the event that modular cables or an RJ-11 to

DB9F adapter is not available, the following table and diagram provide information

so that the cable can be fabricated on site. Refer to “RS-232 Menu” on page 13 for

proper RS-232 port configuration settings.

RS-232 Pinouts

PIN # DESCRIPTION

1 CTS

2 GND

3 RXD

4 TXD

5 RTS

6 N/C (Not connected)

Front

Top

PC to TPS-4000 Cable Specifications (Crestron Cable Number STCP-502PC)

Operations Guide - DOC. 6268 10.4 Inch Tilt Touchpanel: Crestron Isys

TPS-4000 • 15