Specifications

Crestron TPS-VID Video Card for TPS/Tilt Panel
Operations & Installation Guide - DOC. 5869A Video Card for TPS/Tilt Panel: TPS-VID •• 5
NOTE: The diagrams in this procedure show a TPS-6000 touchpanel
but the steps for installation into all Isys™ tilt touchpanels is identical.
1. To prevent errors when re-connecting, label and disconnect all
cables attached to the touchpanel rear panel ports.
2. If necessary, use the touchpanel position lock buttons to adjust
the touchscreen to the maximum (most vertical/upright) angle.
3. To prevent scratching of the screen, place the touchpanel face-
down onto a padded surface.
4. With one hand, hold the touchpanel base cover in place.
5. Refer to the diagram below. Using a #1 Phillips screwdriver,
loosen and remove the eight screws that secure the touchpanel
base cover.
TPS-VID Installation (1 of 6) - Remove Touchpanel Base Cover Screws
TPS-6000
ZA*****
SEE MANUAL
FCC ID: EROTPS-6000
C000000
USE POWER PACK PW-2420RU
ELECTRONICS, INC
Rockleigh, NJ 07647
U.S.A.
ELECTRONICS, INC
Rockleigh, NJ 07647
U.S.A.
CLEAN PANEL WITH SOFT CLOTH ONLY
READ INSTRUCTION MANUAL BEFORE OPERATING
NO USER SERVICABLE PARTS UNDER THIS COVER
6. Place the touchpanel upright on the work surface.
7. As shown on the next page, remove the touchpanel base cover
by raising it upwards and rearward.