Specifications

Video Card for TPS/Tilt Panel Crestron TPS-VID

4 •• Video Card for TPS/Tilt Panel: TPS-VID Operations & Installation Guide - DOC. 5869A

than the device for which it was intended, it may lockup the control system which would then

have to be returned to Crestron. Update files with an “S” designator are for the ST-CP, “V”

designator for CEN/CN-TVAV, “W” for CNRACKX/-DP, and “X” for CNMSX-AV/Pro

control systems. Control systems are able to recognize and reject incorrect update files.

However, when updating control systems, do not ignore any Crestron Viewport warning

prompts or messages.

6 These control systems do not support loading of firmware or VT Pro-e files to the TPS-series

touchpanels through the RS-232 port of the control system. In order to load these files to the

TPS touchpanel when using these control systems, either use the RS-232 port on the TPS

touchpanel or use Ethernet direct to the panel (assuming the TPS-ENET Ethernet Card is

installed).

As of the date of manufacture, this unit has been tested and found to

comply with specifications for CE marking.

NOTE: This device complies with part 15 of the FCC rules. Operation is

subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Installation and Hookup

The TPS-VID is designed to be installed into a specific expansion slot in

the TPS touchpanel. The only tools required for installation are a #1

Phillips screwdriver and a grounding strap (or grounded workstation).

CAUTION: The TPS-VID and the touchpanel contain electro-static

discharge (ESD) sensitive devices. Perform the following procedure

while wearing a grounding strap that is properly grounded and on a

grounded work station to avoid damaging the TPS-VID and/or the

touchpanel.

CAUTION: To prevent stripping of screw heads, threads, or mounting

holes, do not overtighten screws. Tighten only to the specification listed

in the individual step(s).

NOTE: If the angle of the touchscreen needs to be adjusted, consult

latest revision of the appropriate operations guide for instructions of how

to use the touchpanel position lock buttons. The latest version of the

operations guide can be obtained from the Products page (PRODUCT

MANUALS, Hardware section) or Downloads page (MANUAL Library)

of Crestron’s website (www.crestron.com). New users are required to