Specifications

RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA-BV
12 •• RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV Operations & Installation Guide - DOC. 5920
13. Position the touchpanel base cover onto the base.
14. Hold the touchpanel base cover in place and position the
touchpanel face-down onto a padded surface to prevent
scratching of the screen.
15. Re-install the eight base cover screws to finger-tight then,
using a #1 Phillips screwdriver, tighten an additional 1/8-turn.
NOTE: The TPS-IMC, optional TPS-IMW, and TPS-IMC-BV serve as
an interface between the touchpanel and the video source computer
and/or the Cresnet system. If the touchpanel is equipped with optional
TPS-VID Video Card, the audio and video cables from the TPS-IMC to
the touchpanel are replaced with the triamese cable. The TPS-IMC must
be replaced by the TPS-IMC-BV. For further information, consult the
TPS-IMC-BV Operations Guide (Doc. 5921). The latest revision can be
obtained from the Products page (PRODUCT MANUALS section) or
Downloads page (MANUAL Library) of Crestron’s website
(www.crestron.com). New users are required to register to obtain access
to the FTP site.
16. Refer to the diagram below. At the rear of the touchpanel base,
attach the triamese cable (supplied) connector labeled AUDIO
to the AUDIO port, the non-labeled connector to the RGB
port, and the connector labeled NET to the NET/VIDEO port.
Installation Diagram 7 of 7 - Attach Triamese Cable Connectors
HEADPHONES
AUDIO
LANRS-232
NET/VIDEO
24VDC 2.0A
AUDIO
CONNECTOR
RGB
RGB CONNECTOR
(NOT LABELED)
NET
CONNECTOR
17. Re-connect any cables that were disconnected in step 2 to the
appropriate ports on the rear of the touchpanel base.
18. If the optional external power pack is utilized with the
touchpanel, connect the output plug of the power pack to the
24VDC 2.0A port on the rear of the touchpanel base.