This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc.
Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel Contents RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV 1 Description Functional Description Physical Description Leading Specifications Computer Video Connector Signals Preparation Installation and Hookup Touchpanel Setup Configuring the Touchpanel SIMPL™ Windows® Programming VT Pro-e Setup Problem Solving Troubleshooting Further Inquiries Future Updates Future Firmware Upgrades Appendix: Optional Touchpa
Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV Description Functional Description The TPS-XVGA-BV RGB computer interface card with balanced video is an optional feature designed for Crestron’s Isys™ TPS-5000 and TPS-6000 tilt touchpanels.
RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA-BV Supplied with the TPS-XVGA-BV is a TPS-IMC-BV Interface Module that serves as an interface between the touchpanel and the video source computer and/or the Crestron remote control system (herein referred to as the Cresnet system) and a triamese cable (three shielded cables within a single jacket, shown below).
Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel The card contains a 60-pin connector that attaches directly to the motherboard and a 10-position RJ45 connector for the computer video. The video connector (labeled RGB on the touchpanel) is accessible at the rear of the touchpanel base. Mounted on top of the card is a cooling fan assembly to maintain the proper operating temperature of the card during operation. TPS-XVGA-BV Side View 1.21 in (3.
RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA-BV Leading Specifications The table below provides a summary of leading specifications for the TPS-XVGA-BV. Dimensions and weight are rounded to the nearest hundredth unit. Leading Specifications of the TPS-XVGA-BV SPECIFICATION Power Requirements SIMPL™ Windows® VisionTools™ Pro-e Isys Touchpanel Firmware CEN/CN-TVAV Update File CNMSX-AV/Pro Update File CNRACKX/-DP Update File ST-CP Update File CNMS, CNRACK, CNLCOMP Operating System Max.
Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel for which it was intended, it may lockup the control system which would then have to be returned to Crestron. Update files with an “S” designator are for the ST-CP, “V” designator for CEN/CN-TVAV, “W” for CNRACKX/-DP, and “X” for CNMSX-AV/Pro control systems. Control systems are able to recognize and reject incorrect update files. However, when updating control systems, do not ignore any Crestron Viewport warning prompts or messages.
RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA-BV CAUTION: The TPS-XVGA-BV contains ESD sensitive devices. Perform the following procedure while wearing a grounding strap that is properly grounded or on a grounded work station to avoid damaging the card and/or the touchpanel. 1. Carefully open the shipping box and remove the ESD prevention bag that contains the TPS-XVGA-BV. 2. Carefully open the ESD prevention bag and remove the TPS-XVGA-BV.
Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel Installation and Hookup The TPS-XVGA-BV is designed to be installed into a specific expansion slot in the TPS-5000 and TPS-6000 touchpanels. The only tools required for installation are a #1 Phillips screwdriver and a grounding strap (or grounded workstation). CAUTION: The TPS-XVGA-BV and the touchpanel contain ESD sensitive devices.
RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA-BV Installation Diagram 1 of 7 - Remove Touchpanel Base Cover Screws CLEAN PANEL WITH SOFT CLOTH ONLY ELECTRONICS, INC Rockleigh, NJ 07647 U.S.A. READ INSTRUCTION MANUAL BEFORE OPERATING NO USER SERVICABLE PARTS UNDER THIS COVER ELECTRONICS, INC Rockleigh, NJ 07647 U.S.A. FCC ID: EROTPS-6000 SEE MANUAL USE POWER PACK PW-2420RU TPS-6000 ZA***** C000000 7. Place the touchpanel upright on the work surface. 8.
Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel 9. Refer to the diagram below. Using a #1 Phillips screwdriver, loosen, remove and discard the two screws that secure the RGB port blank plate. From the inside of the touchpanel base, remove the plate and discard. Installation Diagram 3 of 7 - Remove RGB Port Blank Plate CAUTION: During the next step, to prevent tearing or distorting the touchpanel label, tighten the plate mounting screws only to the specification described. 10.
RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA-BV Installation Diagram 4 of 7 - Install Port Access Plate CAUTION: To minimize possible damage during shipping, the TPS-XVGA-BV contains packing material between the fan assembly and the card. The packing material must be removed to prevent over-heating of the card during operation. If not removed, refer to “Preparation” that begins on page 5 for instructions.
Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel Installation Diagram 5 of 7 - Install TPS-XVGA-BV 12. Refer to the diagram below. Install the four card mounting screws (supplied), tighten to finger-tight then, using a #1 Phillips screwdriver, tighten an additional 1/8-turn. Installation Diagram 6 of 7 - Install TPS-XVGA-BV Mounting Screws Operations & Installation Guide - DOC.
RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA-BV 13. Position the touchpanel base cover onto the base. 14. Hold the touchpanel base cover in place and position the touchpanel face-down onto a padded surface to prevent scratching of the screen. 15. Re-install the eight base cover screws to finger-tight then, using a #1 Phillips screwdriver, tighten an additional 1/8-turn.
Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel Touchpanel Setup Configuring the Touchpanel To configure the touchpanel for RGB computer video input, consult the latest revision of the TPS-5000 or TPS-6000 Operations Guide (Doc. 5863 or 5864, respectively). The latest version of the Operations Guide can be obtained from the Products page (PRODUCT MANUALS section) or the Downloads page (MANUAL Library) of Crestron’s website (www.crestron.com).
RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA-BV Problem Solving Troubleshooting The table below provides corrective action for possible trouble situations. If further assistance is required, please contact a Crestron customer service representative. TPS-XVGA-BV Troubleshooting TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION At PC, adjust vertical refresh rate to a lower refresh rate. 1 Verify proper connections at touchpanel RGB port, TPS-IMC-BV, and PC.
Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel Further Inquiries If after reviewing this Operations & Installation Guide, you cannot locate specific information or have questions, please take advantage of Crestron's award winning customer service team by calling: • In the US and Canada, call Crestron’s corporate headquarters at 1-888-CRESTRON [1-888-273-7876] or 1-201-767-3400. • In Europe, call Crestron International at +32-15-50-99-50.
RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA-BV Appendix: Optional Touchpanel Setups Optional touchpanel setups that utilize the TPS-XVGA-BV include serial mouse control driver software and instructions to integrate a Boeckeler Pointmaker® Video Marker telestrator with the touchpanel and Cresnet system. Serial Mouse Control Driver The serial mouse control driver software allows the TPS touchpanel to function as a touchscreen monitor.
Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel Telestrator Video Annotation Device TPS touchpanels equipped with TPS-XVGA expansion cards can be integrated with the Boeckeler Pointmaker® Video Marker (model PVI-83) telestrator, a video annotation device by Boeckeler Instruments (www.pointmaker.com). This device (acquired separately) is used to enhance a video presentation by enabling users to emphasize key points or annotate details of an image.
RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA-BV Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange, or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact the factory and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the problem, name and phone number of contact person, RMA number, and return address. 2.
Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel This page intentionally left blank. Operations & Installation Guide - DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations & Installation Guide - DOC. 5920 08.01 Specifications subject to change without notice.
