Installation guide

Crestron TPS-VID-1 / TPS-VID-2 Video Card for TPS/Tilt Panel
TPS-VID-1/VID-2 Top View
3.35 in
(8.51 cm)
5.93 in
(15.06 cm)
2.41 in
(6.12 cm)
NOTE: The TPS-VID-1 circuit board is slightly less populated than the
TPS-VID-2
Industry Compliance
As of the date of manufacture, the card has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling (N11785).
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Installation and Hookup
The TPS-VID-1 and TPS-VID-2 video cards are designed for installation
into a dedicated expansion slot on the TPS touchpanel. The only tools
required for installation are a #1 Phillips screwdriver and a grounding
strap (or grounded workstation).
CAUTION: The TPS-VID-1, TPS-VID-2, and the touchpanel contain
electro-static discharge (ESD) sensitive devices. Perform the following
Operations & Installation Guide - DOC. 6059 Video Card for TPS/Tilt Panel: TPS-VID-1/TPS-VID-2 • 5