Installation guide

Video Card for TPS/Tilt Panel Crestron TPS-VID-1 & TPS-VID-2
NOTE: Crestron software and any files on the Crestron website are for
Authorized Crestron dealers only. New users may be required to register
to obtain access to certain areas of the site (including the FTP site).
Physical Description
The TPS-VID-1 and TPS-VID-2 card, shown in the following diagrams
below, is a printed circuit board (PCB) that is designed for installation
into a dedicated expansion slot on the touchpanel motherboard. The card
contains a 60-pin connector that attaches directly to the motherboard and
is secured with four mounting screws (supplied with each model of the
video card). A 10-position RJ45 port (labeled NET/VIDEO on the
touchpanel) is permanently attached to the motherboard and is accessible
through the connector panel at the rear of the touchpanel base. Refer to
the following diagrams for physical dimensions.
TPS-VID-1/VID-2 VIDEO CARD (TPS-VID-2 Shown)
TPS-VID-1/VID-2 Side View
4 • Video Card for TPS/Tilt Panel: TPS-VID-1/TPS-VID-2 Operations & Installation Guide - DOC. 6059
0.71 in
(1.81 cm)
TOUCHPANEL CONNECTOR