Installation guide

Video Card for TPS/Tilt Panel Crestron TPS-VID-1 & TPS-VID-2
The TPS-VID-1 can automatically detect composite or S-video. The
TPS-VID-2 uses the “C” input for a second composite video source (on
the TPS-VID-2, Composite/S-Video can be auto-detected only when
input signal 2 is not used). Video signals to the touchpanel are supplied
through a Crestron TPS interface module (IMC) that is provided with the
touchpanel or an optional TPS wall-mounted interface module (IMW).
When using the TPS-VID-2 for receiving two video sources, the
“Comp/Y” connection will be used for Video Source 1 while the chroma
“C” connection will be used for Video Source 2.
Refer to the table below for touchpanel and interface modules that can be
used with TPS-VID cards.
Touchpanel Interface Module Compatibility
ISYS™
TOUCHPANEL
INTERFACE
MODULE
MODULE
AVAILABILITY MODULE DOC. #
TPS-
4500IMC
Supplied
w/touchpanel
5890
TPS-4500
TPS-
4500IMW
Sold Separately 5913
TPS-IMC
Supplied
w/touchpanel
5856
TPS-IMC-BV Sold Separately 5921
TPS-5000
and/or
TPS-6000
TPS-IMW Sold Separately 5857
*The TPS-IMC-BV is supplied with the optional TPS-XVGA-BV card that can
only be installed into specific touchpanels. Refer to the TPS-XVGA-BV
Operations and Installation Guide (Document 5920) for further information.
NOTE: For more information about the Crestron TPS interface or wall-
mounted interface module(s), refer to the latest revision of the
appropriate operations guide. The latest versions can be obtained from
the Downloads | Product Manuals section of the Crestron website
(www.crestron.com
).
Specifications
The following table provides a summary of specifications for the
TPS-VID-1 and TPS-VID-2 cards.
2 • Video Card for TPS/Tilt Panel: TPS-VID-1/TPS-VID-2 Operations & Installation Guide - DOC. 6059