Installation guide

Video Card for TPS/Tilt Panel Crestron TPS-VID-1 & TPS-VID-2
Video Setup
3. The touchpanel can be configured to auto-detect the signal type
(S-Video or Composite) coming in to the touchpanel or can be
set to a specific signal type (S-Video or Composite). Select the
appropriate signal type.
NOTE: When configuring the TPS-VID-2, the Video 1 signal type can
be automatically detected as long as one signal is sent to the touchpanel.
NOTE: A solid blue screen is displayed in the video window if a video
signal is not detected or is very weak. Verify that the video source is
functioning and properly connected. If the source is properly connected
and functioning, a distribution amplifier may need to be used.
4. Select the preferences for the video signals appearance. Refer to
the following table for further information.
Video Setup Details
VIDEO
SCREEN
BUTTONS
DESCRIPTION
Brightness Use to increase or decrease image brightness.
Contrast Use to increase or decrease image contrast.
(continued on next page)
14 • Video Card for TPS/Tilt Panel: TPS-VID-1/TPS-VID-2 Operations & Installation Guide - DOC. 6059