Installation guide

Video Card for TPS/Tilt Panel Crestron TPS-VID-1 & TPS-VID-2
NOTE: When using the TPS-VID-2 for receiving two composite video
sources, the “Comp/Y” connection will be used for Video Source 1 while
the chroma (C) connection will be used for Video Source 2.
NOTE: A variety of video wiring combinations can be used. For
example, Signal 1 can be connected to the BNC connector while Signal 2
can use the twisted pair connector. Do not apply different video signals to
the BNC and twisted pair connector for the same input (i.e. one signal on
BNC “Y” input and a different source signal on the twisted pair “Y”
input).
NOTE: When connecting cables to a TPS-IMC-BV, select the
connection to use (BAL or COAX) by sliding the switch to the
appropriate setting that is accessible through the opening in the cover of
the TPS-IMC-BV. Only one connection type can be used at a time.
NOTE: For additional information on video connections over CAT 5,
refer to the latest version of the Crestron CAT 5 Wiring Reference Guide
(Doc. 6137) which is available from the Downloads | Product Manuals
section of the Crestron website (www.crestron.com).
14. Re-connect all cables to the appropriate ports on the rear of the
touchpanel.
Setup
Configuring the Touchpanel
NOTE: Refer to the latest revision of the TPS-4500, TPS-5000, or
TPS-6000 Operations & Installation Guide (Doc. 5891, 5863, or 5864,
respectively) for instructions to access the touchpanel setup screen. The
latest version of the operations guide can be obtained from the
Downloads | Product Manuals section of the Crestron website
(www.crestron.com).
1. From the MAIN MENU, select the SETUP button to access the
touchpanel SETUP MENU.
12 • Video Card for TPS/Tilt Panel: TPS-VID-1/TPS-VID-2 Operations & Installation Guide - DOC. 6059