Installation guide

Crestron TPS-VID-1 / TPS-VID-2 Video Card for TPS/Tilt Panel
the cable assembly to the NET/VIDEO port of the appropriate
interface module (TPS-IMC is shown) or to the TPSBLOCK-10
interface (refer to the latest version of the TPSBLOCK-10
Installation Guide, Doc. 5979 for functional and physical
description).
NOTE: When connecting the Net/Video cable from the interface
module to the touchpanel, exceeding a cable length of 30 feet will
significantly degrade the video signal. To maintain high-quality video,
DO NOT daisy-chain cables or Crestron TPSBLOCK-10 cables longer
than 30-feet. Contact Crestron for the maximum available cable length.
TPS-VID-1/VID-2 Installation (6 of 6) – Attach 10-Pin Net/Video
Cable Assembly
HEADPHONES AUDIO RGB LANRS-232 NET/VIDEO 24VDC 2.0A
CRESTRON
TPS - IMC
NET
Z
AUDIO
PANEL
AUDIO
INPUT
+S
R
S
MIC
OUT
S
L
+
_ _
+
_
TO
VIDEO
NET/
+
_
Y
COMP
S
NTSC/PAL VIDEO
+ S
C
C
_
Y
COMP
GY24
10-POSITION
NET/VIDEO CABLE
ASSEMBLY
CONNECT TO VIDEO SOURCE(S)
FOR TPS-VID-2, USE "COMP/Y"
FOR SIGNAL 1 AND "C" FOR SIGNAL 2
TOUCHPANEL
TPS-IMC
CONNECTED
TO CRESNET
To display video from the TPS-VID-1/2,
Cresnet power MUST be con-
nected to the TPS-IMC. If utilizing
the TPS-IMC-BV, an external power
pack may be connected to the
TPS-IMC-BV to supplement
Cresnet power or if Cresnet
power is not available.
NOTE:
CAUTION: When running unbalance video, the respective twisted-pair
jumper(s) must be installed to avoid damage to the TPS-IMC. Refer to
the latest version of the TPS-IMC Operations Guide (Doc. 5856) for
hardware hookup details.
Operations & Installation Guide - DOC. 6059 Video Card for TPS/Tilt Panel: TPS-VID-1/TPS-VID-2 • 11