Installation guide

Video Card for TPS/Tilt Panel Crestron TPS-VID-1 & TPS-VID-2
TPS-VID-1/VID-2 Installation (5 of 6) – Re-install Touchpanel Base
Cover Screws
TPS-6000
ZA*****
SEE MANUAL
FCC ID: ER OTPS-6000
C000000
USE POW ER PACK PW-2420RU
ELECTRONICS, INC
Rockleigh, NJ 07647
U.S.A.
ELECTRONICS, INC
Rockleigh, NJ 07647
U.S.A.
CLEAN PANEL WITH SOFT CLOTH ONLY
READ I NSTRUCTIO N MANUAL BEFOR E OPERATING
NO USER SERV ICABLE PARTS UNDE R THIS COVER
The following table is provided as reference information about the
pinouts of the NET/VIDEO connector.
Pin Assignments
TYPE PIN DESIGNATION DESCRIPTION
1 +24V Power (Network)
2 GND Ground (Network)
3 C+ Chrominance (Positive)
4 C- Chrominance (Negative)
5 Y Data (Network)
6 Z Data (Network)
7 Y+ Luminance (Positive)/Composite
8 Y- Luminance (Negative)/Composite
9 GND Ground (Network)
10-pin RJ45
Pin 1
Pin 1
10 +24V Power (Network)
CAUTION: The 10-pin RJ45 Net/Video connector cable supplied by
Crestron is a custom cable and is the only one that should be used. The
end of the cable has a metal shield that is required to protect the
equipment. Using non-Crestron cables will result in damage to the
product.
13. Refer to the following diagram for the video connector signals
and attach the supplied 10-pin Net/Video cable assembly (or
the triamese cable assembly supplied with the TPS-IMC-BV) to
the Net/Video port of the touchpanel. Connect the other end of
10 • Video Card for TPS/Tilt Panel: TPS-VID-1/TPS-VID-2 Operations & Installation Guide - DOC. 6059