Installation guide

Crestron TPS-VID-1 / TPS-VID-2 Video Card for TPS/Tilt Panel
TPS-VID-1/VID-2 Installation (4 of 6) – Install TPS-VID-1/VID-2
Mounting Screws
10. Position the touchpanel base cover onto the base by tilting the
front of the cover downward under the touchpanel pivot and
lowering the base cover.
11. Hold the touchpanel base cover in place and position the
touchpanel face-down onto a padded surface to prevent
scratching of the screen.
12. Re-install the eight base cover screws to finger-tight then,
using a Phillips screwdriver, tighten each screw an additional
1/8-turn. Refer to the following diagram for screw locations.
Operations & Installation Guide - DOC. 6059 Video Card for TPS/Tilt Panel: TPS-VID-1/TPS-VID-2 • 9