Installation guide

Video Card for TPS/Tilt Panel Crestron TPS-VID-1 & TPS-VID-2
8. Align the pins on the touchpanel interface connector of the
TPS-VID-1 or TPS-VID-2 with the touchpanel motherboard
connector. DO NOT force pins into connector. Press the TPS-
VID-1/VID-2 until the pins are fully seated. Make sure that the
screw holes of the card align with the mounting posts on the
motherboard. Refer to the following diagram for a detailed
view.
TPS-VID-1/VID-2 Installation (3 of 6) – Install TPS-VID-1/VID-2
9. Install the four mounting screws (supplied), tighten to
finger-tight then, using a Phillips screwdriver, tighten each
screw an additional 1/8-turn. Refer to the following diagram for
screw locations.
8 • Video Card for TPS/Tilt Panel: TPS-VID-1/TPS-VID-2 Operations & Installation Guide - DOC. 6059