Installation guide

Video Card for TPS/Tilt Panel Crestron TPS-VID-1 & TPS-VID-2
procedure while wearing a grounding strap that is properly grounded and
on a grounded workstation to avoid damaging the TPS-VID card and/or
the touchpanel.
CAUTION: To prevent stripping of screw heads, threads, or mounting
holes, DO NOT overtighten screws. Tighten only to the specification
listed in the individual step(s).
NOTE: If the angle of the touchscreen needs to be adjusted, consult the
latest revision of the appropriate operations guide for instructions of how
to use the touchpanel position lock buttons. The latest versions of
operations guides can be obtained from the Downloads | Product Manuals
section of the Crestron website (www.crestron.com).
NOTE: The diagrams in this procedure show a TPS-6000 touchpanel
but the installation steps for the TPS-4500 and TPS-5000 Isys™ tilt
touchpanels are identical.
1. To prevent errors when re-connecting, label and disconnect all
cables attached to the touchpanel’s rear ports.
2. If necessary, use the touchpanel position lock buttons to adjust
the touchscreen to the maximum (most vertical/upright) angle.
3. To prevent scratching of the screen, place the touchpanel
face-down onto a padded surface.
4. With one hand, hold the touchpanel base cover in place.
5. Using a #1 Phillips screwdriver, loosen and remove the eight
screws that secure the touchpanel base cover. Refer to the
following diagram for screw locations.
6 • Video Card for TPS/Tilt Panel: TPS-VID-1/TPS-VID-2 Operations & Installation Guide - DOC. 6059