Specifications

Crestron Touch The PC Driver Software
Select Project Properties
4. In the “Project Properties” window, select the Pad Area tab.
5. Refer to the diagram below. In the Type drop-down list of the desired
Pad Area, select Touch The PC V2 (Pad Area 1 is shown).
NOTE: If the Touch The PC V2 selection does not appear, update the Crestron
Database to version 16.2 or later.
Select Touch The PC V2 in Pad Area 1
6. In the Communication via drop-down list of the “Project Properties”
window, select either Serial or Cresnet or TCP/IP (for Ethernet
operation) and continue with this step.
Programmer’s Guide – DOC. 5916B Touch the PC Driver
• 15