Specifications

Software Crestron Touch The PC Driver

IP Table

3. As shown below, using the addm (ADDMASTER) command to add a

CIP node to the master list of the touchpanel, enter the information in

the following format with spaces (no period or underscore) between the

entries: CIP ID from SIMPL Windows (example of 4 is shown), IP

address of touchpanel (example of 132.149.010.147 is shown), and

Device ID (example of 4 is shown). To remove an IP address, use the

REMM command.

NOTE: The Device ID of the Touch the PC V2 does not have to match the CIP

ID. It will also be used in step 6 of “VT Pro-e Programming” that begins on page 14.

4. As shown below, use the ipt command to display the updated IP table

on the touchpanel.

Updated IP Table

5. Proceed to “SIMPL Windows Programming” that begins on the next

page.

• Touch the PC Driver Programmer’s Guide – DOC. 5916B