Specifications

Crestron Touch The PC Driver Software
NOTE: A Crestron TPS-ENET or TPS-ENETL Ethernet expansion card must be
installed in the touchpanel to enable Ethernet communication. For further
information, refer to the TPS-ENET or TPS-ENETL Operations & Installation
Guide (Doc. 6016 or 6013, respectively). The latest revisions can be obtained from
the Downloads | Product Manuals section of the Crestron website
(www.crestron.com
). New users are required to register to obtain access to the FTP
site.
NOTE: The Crestron control system must contain an Ethernet expansion card to
enable Ethernet communication. On CNX Generation control systems, the port may
be labeled LAN or LAN/DPA. On 2-Series control systems, the port may be labeled
LAN A or LAN B. For further information about CNX Generation Ethernet cards,
refer to the CNXENET or CNXENET+ Operations & Installation Guide (Doc. 8129
or 8153, respectively). For further information about 2-Series Ethernet cards, refer to
the C2ENET-1/-2 Operations & Installation Guide (Doc. 5962). The latest revisions
can be obtained from the Downloads | Product Manuals section of the Crestron
website (www.crestron.com
).
Cabling Connections
For Touch the PC V2 operation using Ethernet communication with the PC, refer to
the steps below.
1. Refer to the appropriate (for TPS-XVGA, TPS-XVGA-BV, or TPS-
XVGAL card) diagrams and tables which follow and make the cable
connections.
Ethernet Communication #1 - Tilt Touchpanel with TPS-XVGA
TO
RGB
PORT
RGB CABLE
PC
LAN
PORT
ETHERNET
WIRING
COM
PORT
CONTROL
SYSTEM
ETHERNET
ROUTER/HUB
COM
PORT
TILT TOUCHPANEL
WITH TPS-XVGA
VGA
PORT
A
COMM. CABLE
B
D
C
LAN
PORT
POWER
PACK
E
24VDC
2.0A
PORT
BKLT
MENU
PROFESSIONAL CONTROL PROCESSOR
PRO
2
CRESTRON
PORT CONNECTOR to CONNECTOR DEVICE PORT
A
1
VGA DB-15, male DB-15, male Touchpanel RGB
B
2
COM DB-9, female DB-9, female Control System COM
C
3
LAN RJ-45, 8-pin RJ-45, 8-pin Ethernet / Hub na
D
3
na RJ-45, 8-pin RJ-45, 8-pin Touchpanel LAN
E
4
na na Touchpanel 24VDC 2A
1
2
3
4
REF
ETHERNET COMMUNICATION #1 - TILT TOUCHPANEL WITH TPS-XVGA CARD
CABLING REQUIRED TO
DEVICE
PC
Standard Ethernet cables (ref C & D).
Standard stranded VGA monitor cable.
PC
Standard null modem serial cable.
FROM
Ethernet / Hub
PWR. PACK
Control System
Power pack (PW-2420RU) is NOT required if power is supplied via Cresnet.
Programmer’s Guide – DOC. 5916B Touch the PC Driver
• 9