Specifications

Software Crestron Touch The PC Driver
PORT CONNECTOR to CONNECTOR DEVICE PORT
A
1
VGA DB-15, male DB-15, male TPS-IMC-BV RGB
B
2
RGB RJ-45, 10-pin RJ-45, 10-pin Touchpanel RGB
C
3
COM DB-9, female DB-9, female Control System COM
D
NET 4-wire Cresnet 4-wire Cresnet TPS-IMC-BV NET
E
2
NET/VIDEO RJ-45, 10-pin RJ-45, 10-pin Touchpanel NET/VIDEO
1
2
3
REF
CRESNET COMMUNICATION #2 - TILT TOUCHPANEL WITH TPS-XVGA-BV CARD
PC
TPS-IMC-BV
Standard null modem serial cable.
FROM CABLING REQUIRED
DEVICE
These connections (ref B & E) can be made with the 15-foot Triamese cable supplied with the TPS-IMC-BV if an
audio connection is also desired.
Control System
PC
Standard stranded VGA monitor cable.
TO
TPS-IMC-BV
Cresnet Communication #3 - Lectern Touchpanel with TPS-XVGAL
RGB
INPUT
PORT
RGB CABLE
PC
LECTERN TOUCHPANEL
(OR TPS-TPI) WITH
TPS-XVGAL
CRESNET
WIRING
COM
PORT
CONTROL
SYSTEM
NET
PORT
COM
PORT
VGA
PORT
NET (OR
CRESNET)
PORT
A
B
COMM. CABLE
C
BKLT
MENU
PROFESSIONAL CONTROL PROCESSOR
PRO
2
CRESTRON
PORT CONNECTOR to CONNECTOR DEVICE PORT
A
1
VGA DB-15, male BNC-5, male Touchpanel RGB
B
2
COM DB-9, female DB-9, female Control System COM
C
NET 4-wire Cresnet 4-wire Cresnet Touchpanel NET
1
2
Standard null modem serial cable.
PC
A standard stranded VGA monitor cable with DB15F to BNC-5 adapter is required. Both are commercially
available.
Control System
PC
REF
CRESNET COMMUNICATION #3 - LECTERN TOUCHPANEL WITH TPS-XVGAL CARD
FROM CABLING REQUIRED TO
DEVICE
2. Proceed to “VT Pro-e Programming” that begins on page 14.
PC to Touchpanel Ethernet Communication
For Touch the PC V2 operation using Ethernet communication from the PC to the
touchpanel, refer to the following two sections, “Cabling Connections” and
“Ethernet Setup.”
NOTE: To connect the LAN port on the control system and the LAN port on the
touchpanel base directly instead of through an Ethernet hub, use an Ethernet
crossover cable (not supplied).
8
• Touch the PC Driver Programmer’s Guide – DOC. 5916B