Specifications

Crestron Isys™ TPS-6000L 15 Inch Lectern Touchpanel
10. Repeat steps 7 through 9 for the bottom horizontal edge of the opening.
11. Attach the network cable and other RS-232, audio, video, or Ethernet
cables in the wall to the appropriate connector on the back of the
touchpanel. Refer to "Network Wiring" on page 6 for network wiring
details. Information about the RS-232, microphone, and audio input
connectors are located in "I/O Connectors" on page 2. For wiring the
other connectors, refer to the appropriate Operations & Installation
Guide for each expansion card.
12. Position the touchpanel (less the faceplate) into the opening and secure
with eight pan head screws, supplied. Tighten by hand; do not fully
tighten screws.
Positioning Touchpanel into Opening
DRYWALL
NOTE:
WIRING NOT SHOWN
FOR CLARITY
POSITION
AND SECURE
TOUCHPANEL
INTO OPENING
13. Use the #2 Phillips screwdriver and fully tighten all 12 pan head
screws. Use caution and do not crack or damage mounting surface.
14. Mate the four posts of the bezel with the holes drilled into the mounting
surface and firmly press on the bezel over the touchpanel.
Cover Touchpanel with Bezel
DRYWALL
NOTE:
WIRING NOT SHOWN
FOR CLARITY
COVER
TOUCHPANEL
WITH BEZEL
Operations Guide - DOC. 5825 15 Inch Lectern Touchpanel: Crestron Isys™ TPS-6000L • 9