Specifications

15 Inch Lectern Touchpanel Crestron Isys™ TPS-6000L
TPS-6000L Supplied Mounting Hardware and Accessories
ITEM PART NUMBER QUANTITY
Large Metal Mounting Plate MTPL02551-1 2
Small Metal Mounting Plate MTPL02523-1 2
Template OV40051-1 1
Screw, Pan Phillips #6-32 x 1" LG 12
Network Connector JHPS197SG04SR-2 1
Microphone Connector JHPS135SG03SR-1 1
Audio Input Connector JHPS135SG06SR-1 1
Complete the following installation procedure in the order provided. The only tools
required are a gypsum board saw (or equivalent), a #2 Phillips tip screwdriver, a
drill, a 5/16" bit, and a #20 bit. Complete the following installation procedure in the
order provided.
1. Locate an area on the wall that is free of miscellaneous wiring and
studs.
2. Make a small hole near the middle of the designated site; verify that the
location is suitable.
3. Fasten cutout template (40051, supplied) to mounting surface; verify
that the template is level.
4. Cut out and remove the traced shape of the mounting surface.
5. Drill four 5/16” holes as marked on template. Refer to "Appendix C:
Cutout Detail of Supplied Template" on page 42 for an illustrative
reference.
6. Drill 12 holes marked "A" on template with #20 bit. Refer to
"Appendix C: Cutout Detail of Supplied Template" on page 42 for an
illustrative reference.
7. Slide one large metal mounting plate through the opening and position
it inside along the top horizontal edge.
8. Position one small metal mounting plate along the top horizontal edge
so that it covers the two center holes marked "A".
9. Use two pan head screws, supplied, to secure the bracket and plate to
the mounting surface. Tighten by hand; do not fully tighten screws.
Securing Two Plates to Top and Bottom Edges of Opening
TWO PAN
HEAD
SCREWS
(MOUNTS PLATES
IN TWO CENTER
TAPPED HOLES)
DRYWALL
LARGE
METAL
MOUNTING
PLATE
SMALL
METAL
MOUNTING
PLATE
8 • 15 Inch Lectern Touchpanel: Crestron Isys™ TPS-6000L Operations Guide - DOC. 5825