Specifications

Crestron Isys™ TPS-5000 12 Inch Tilt Touchpanel

This 10-pin RJ-45 port provides network connection from the touchpanel to the

interface module and network power to the touchpanel. This port also contains the

composite and S-video connections if a TPS-VID-1 or TPS-VID-2 is installed in the

TPS-5000. Refer to the descriptions and pinout table that follow this paragraph.

Pin Assignments

TYPE PIN DESIGNATION DESCRIPTION

1 +24V Power (Network)

2 GND Ground (Network)

3 C+ Chrominance (Positive) /Composite 2

4 C- Chrominance (Negative) /Composite 2

5 Y Data (Network)

6 Z Data (Network)

7 Y+ Luminance (Positive)/Composite 1

8 Y- Luminance (Negative)/Composite 1

9 GND Ground (Network)

10-pin RJ-45

Pin 1

10 +24V Power (Network)

To determine the location of pin 1, hold the cable so that the end of the 10-pin RJ-45

connector is facing away from you, with the clip side down and the copper side up.

The copper connector on the far left is pin 1.

NOTE: When using the TPS-VID-1 or TPS-VID-2, pins 3, 4, 7, and 8 are used to

transmit video signals from the touchpanel interface to the TPS-5000. Consult the

latest revision of the TPS-VID-1/VID-2 Operations & Installation Guide (Doc. 6059)

for details.

LAN

This port is activated with the purchase and installation of the TPS-ENET, a 10/100

BaseT Ethernet card. Consult the latest revision of the TPS-ENET Operations &

Installation Guide (Doc. 5867) for details.

24 VDC, 2.0A

This female connector is used to supply 24 VDC power to the TPS-5000 from an

optional power pack (Crestron model PW-2420RU). If video is to be displayed on

the touchpanel, 24 VDC power must be supplied to the TPS-IMPC through either the

Cresnet connector or the TPS-IMPCs 24VDC connector.

CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to

do so could cause equipment damage or void the Crestron warranty.

CAUTION: If power is provided to the TPS-5000 from the +24VDC on a Cresnet

connector or the optional PW-2420RU to the touchpanel base, power must not be

applied to the power input on the TPS-IMPC.

NOTE: Use care in wiring installations to avoid applying 24 VDC power to Cresnet

wiring from multiple sources.

Operations Guide - DOC. 5863A 12 Inch Tilt Touchpanel: Crestron Isys™ TPS-5000 • 21