Specifications

Crestron Isys™ TPS-5000 12 Inch Tilt Touchpanel
Hardware Connections for the TPS-5000
HEADPHONES:
TO EXTERNAL
HEADPHONE
SET
POWER:
TO POWER PACK
(24VDC, 2A OUTPUT)
NET/VIDEO:
TO CRESNET VIA
TPS-IMPC / INPUTS
COMPOSITE OR
S-VIDEO
RS-232:
TO PC OR
ANY RS-232
DEVICE
HEADPHONES AUDIO RGB LANRS-232 NET/VIDEO 24VDC 2.0A
RGB:
RGB VIDEO
INPUT
ETHERNET:
10/100 BASE-T
ETHERNET TO
LAN OR WEB
AUDIO:
STEREO AUDIO INPUT
& MIC OUTPUT VIA
TPS-IMPC
HEADPHONES
Connect this standard mini phone jack (12mW, 32 ohms load) to the plug of an
external headphone set, not supplied.
AUDIO
This 8-pin, RJ-45 connector mates to an interface module with a supplied cable and
provides differential/single ended audio input and output. It also produces line level
differential output. Description of the pinouts is shown in the following table.
AUDIO Pinouts
TYPE PIN DESIGNATION DESCRIPTION
1 L+ Left Input (Positive)
2 L- Left Input (Negative)
3 GND/Shield Audio Input Ground/Shield
4 R+ Right Input (Positive)
5 R- Right Input (Negative)
6 GND/Shield Mic Output Ground/Shield
7 M+ Mic Output (Positive)
1
8
1
8
Front
Top
8 M- Mic Output (Negative)
To determine the location of pin 1, hold the supplied cable so that the end of the
8-pin RJ45 connector is facing away from you, with the clip side down and the
copper side up. The copper contact on the far left is pin 1.
NOTE: When connecting the touchpanel to the interface module, do not confuse the
8-pin audio cable with the 10-pin net/video cable.
RS-232
This 6-pin RJ-11 connector mates with a serial port of a PC. The connecting cable is
not supplied. Prior to installation, use this port for direct connection between the
Operations Guide - DOC. 5863A 12 Inch Tilt Touchpanel: Crestron Isys™ TPS-5000 • 19