Installation guide

Crestron TPS-ENET Ethernet Card for TPS/Tilt Panel
Expanded PRO2 System Tree
C2Z Card Slot in Configuration Manager
The C2Z Card Slot can accept a C2ENET card. Once a C2ENET card is
configured in a C2Z Card Slot, the slot allows Ethernet communication
between the TPS touchpanel and the control system.
In Configuration Manager, drag the C2ENET card (for example, the
C2ENET-2) from the Plug-in Control Cards | Cards (2-Series Z Bus)
folder of the Device Library and drop it on the PRO2 C2Z Card Slot in
System Views. The System Views upper pane displays the Ethernet Units
icon below the PRO2 graphic. The PRO2 system tree displays the
C2ENET-2 in Slot 8 as shown below.
C2ENET-2 Device, Slot 8
Drag the appropriate Ethernet TPS touchpanel (for example, the
TPS-6000 w/TPS-ENET) from the Touchpanels folder and drop it on
Slot 8 in System Views. The lower pane shows the touchpanel in IP-ID as
shown on next page.
Operations & Installation Guide - DOC. 6016 Ethernet Card for TPS/Tilt Panel: TPS-ENET • 19