Installation guide

Ethernet Card for TPS/Tilt Panel Crestron TPS-ENET
2. As shown on below, enter the IP address of the configured
touchpanel and select the Connect button.
“Crestron Viewport TCP/IP Connect” Window
3. If a password had been set for the touchpanel, an access
password is required to connect.
NOTE: To set a password, use Functions | Set TCP/IP Console
Password in Viewport. The “Enter New Password” window appears and
prompts the user to enter and verify a password. You can also disable a
password using Disable Password in the window.
4. As shown below (left), enter the required password. (The
correct password must be entered within three attempts or the
password window shown below (right) displays a password
invalid message.)
Password Windows
5. Observe the Viewport connect to the touchpanel.
Programming
You can create a program that allows you to control the TPS-ENET
equipped TPS touchpanel via Ethernet through a Crestron control system
using the Crestron programming tools Crestron Application Builder™
(AppBuilder) and SIMPL Windows. These tools are intended for users
with different levels of programming knowledge. The flexibility of each
16 • Ethernet Card for TPS/Tilt Panel: TPS-ENET Operations & Installation Guide - DOC. 6016