Installation guide

Crestron TPS-ENETL Ethernet Card for TPS/Lectern Panel
Connector Specifications
Connector Specifications of the TPS-ENETL
PORT TYPE SIGNAL(S)
Touchpanel
Interface
40-pin connector Various
Pin 1 TD+
Pin 2 TD-
Pin 3 RD+
Pin 4
Connected to pin 5
Pin 5
Connected to pin 4
Pin 6 RD-
Pin 7
Connected to pin 8
Pin 8
Connected to pin 7
LAN (8-wire
RJ45)
1
8
1
8
Front
Top
NOTE: To determine which is pin 1 on the cable, hold the cable so that
the end of the eight pin modular jack is facing away from you, with the
clip down and copper side up. Pin 1 is on the far left.
Physical Description
The TPS-ENETL card, shown on the next page, is a printed circuit board
(PCB) that is designed to be installed in a specific expansion slot in the
touchpanel (or interface). The card contains a 40-pin connector and an
8-position RJ45 port. The 40-pin connector attaches directly to the
motherboard. The RJ45 port (labeled LAN on the touchpanel) is
accessible through the connector panel at the rear of the case. The port is
used for connection to the Ethernet (cable is not supplied). The port also
contains two light-emitting diodes (LEDs). The green LED on the left
side of the port is a link status LED and illuminates when the card is
connected to a working network. The yellow LED on the right side
flashes to indicate Ethernet activity. The card is secured to the
motherboard with four attached knurled mounting screws.
Operations & Installation Guide - DOC. 6013 Ethernet Card for TPS/Lectern Panel: TPS-ENETL • 3