Installation guide

Ethernet Card for TPS/Lectern Panel Crestron TPS-ENETL
Viewport Connect TCP/IP
2. As shown below, enter the IP address of the configured
touchpanel and select the Connect button.
“Crestron Viewport TCP/IP Connect” Window
3. If a password has been set for the touchpanel, an access
password is required to connect.
NOTE: To set a password, use Functions | Set TCP/IP Console
Password in Viewport. The “Enter New Password” window appears and
prompts the user to enter and verify a password. You can also disable a
password using Disable Password in the window.
4. As shown on next page (left), enter the required password. (The
correct password must be entered within three attempts or the
password window shown on next page (right) displays a
password invalid message.)
18 • Ethernet Card for TPS/Lectern Panel: TPS-ENETL Operations & Installation Guide - DOC. 6013