Installation guide

Crestron TPS-ENETL Ethernet Card for TPS/Lectern Panel
Accessing the “Port Settings” Window
6. Select the appropriate connection type. Verify that RS-232 and
an available COM port (COM 1 is shown below) is selected.
Verify that the Viewport settings match the RS-232 Menu of
the configured touchpanel. If not, the Viewport settings can be
modified to match the touchpanel settings or the touchpanel
settings can be modified to match the Viewport.
NOTE: The “Port Settings” window (refer to graphic on next page)
shows the default RS-232 settings (Baud Rate: 115200, Parity: None,
Data Bits: Eight, and Stop Bits: One) for TPS panels when shipped from
the factory.
Operations & Installation Guide - DOC. 6013 Ethernet Card for TPS/Lectern Panel: TPS-ENETL • 13