Installation guide

Crestron TPS-ENETL Ethernet Card for TPS/Lectern Panel
Attach Ethernet Cable
CABLE
FROM
ETHERNET
NOTE: Refer to the latest revision of the TPS-5000L, TPS-6000L, or
TPS-TPI Operations Guide (Doc. 5825, 5783, or 5855, respectively) or,
if applicable, BB-5000 or BB-6000 Installation Guide (Doc. 5826 or
5827, respectively) for the proper installation procedure of the
touchpanel. The latest version of the appropriate guide can be obtained
from the Downloads | Product Manuals section of Crestron’s website
(www.crestron.com)
.
Obtaining Communications
To setup the touchpanel for Ethernet communication, it is necessary to
first obtain communication with the device. Communication with the
touchpanel can be established via the local RS-232 port or the host
control system via the remote console mode (Cresnet).
To obtain communication with the touchpanel via RS-232, refer to the
procedure below. To obtain communication with the touchpanel via the
host control system, refer to the remote console procedure beginning on
page 14.
Operations & Installation Guide - DOC. 6013 Ethernet Card for TPS/Lectern Panel: TPS-ENETL • 11