Installation guide

Crestron TPS-ENETL Ethernet Card for TPS/Lectern Panel
7. Tighten the card mounting screws to finger-tight.
CAUTION: The TPS-ENETL connector may have to be aligned slightly
to fit through the opening in the rear cover. Align the connector of this
card (or any other optional card that is installed) carefully to prevent
damage to the card, cover, or touchpanel.
8. As shown on the below, install the touchpanel rear cover by
sliding it over the TPS-ENETL connector.
Install Touchpanel Rear Cover
9. Refer to the diagram on next page. Re-install the 10 rear cover
screws to finger-tight then, using a #1 Philips screwdriver,
tighten an additional 1/8-turn.
Operations & Installation Guide - DOC. 6013 Ethernet Card for TPS/Lectern Panel: TPS-ENETL • 9