Installation guide

Crestron TPS-ENETL Ethernet Card for TPS/Lectern Panel
CAUTION: The connectors of any optional card that is already installed
may have to be aligned slightly to allow the rear cover to be removed.
Align the connectors carefully to prevent damage to the card, cover, or
touchpanel.
3. Remove the touchpanel rear cover by sliding it towards the
bottom of the touchpanel as shown below.
Remove Touchpanel Rear Cover
4. Refer to the diagram on next page. Using a #1 Phillips
screwdriver, loosen and remove the two screws that secure the
PCB blank plate and remove the plate.
Operations & Installation Guide - DOC. 6013 Ethernet Card for TPS/Lectern Panel: TPS-ENETL • 7