Specifications

RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA

6 •• RGB Computer Interface Card for TPS/Tilt Panel: TPS-XVGA Operations & Installation Guide - DOC. 5944

CAUTION: To prevent over-heating of the card during operation, make

sure that the fan electrical connector has remained attached to the PCB

connector of the TPS-XVGA.

Installation and Hookup

The TPS-XVGA is designed to be installed into a specific expansion slot

in the TPS-5000 and TPS-6000 touchpanels. The only tools required for

installation are a #1 Phillips screwdriver and a grounding strap (or

grounded workstation).

CAUTION: The TPS-XVGA and the touchpanel contain ESD sensitive

devices. Perform the following procedure while wearing a grounding

strap that is properly grounded or on a grounded work station to avoid

damaging the card and/or the touchpanel.

NOTE: If the angle of the touchscreen needs to be adjusted, consult

latest revision of the appropriate operations guide for instructions of how

to use the touchpanel position lock buttons. The latest version of the

operations guide can be obtained from the Products page (PRODUCT

MANUALS section) or Downloads page (MANUAL Library) of

Crestron’s website (www.crestron.com). New users are required to

NOTE: The diagrams in this procedure show a TPS-6000 touchpanel

but the steps for installation into the TPS-5000 are identical.

1. If the optional external power pack is utilized, disconnect the

plug of the power pack from the 24VDC 2.0A port on the rear

of the touchpanel base.

2. To prevent errors when re-connecting, label and disconnect any

cables attached to the ports on the rear of the touchpanel base.

3. If necessary, use the touchpanel position lock buttons to adjust

the touchscreen to the maximum (most vertical/upright) angle.

4. To prevent scratching of the screen, place the touchpanel face-

down onto a padded surface.

5. To prevent the touchpanel base cover from falling when the

screws are removed, hold the touchpanel base cover in place.