Specifications

Crestron Isys

TPS-4000L 10.4” Lectern/Wall Mount Touchpanel

NOTE: When sending balanced audio from a CNX-BIPAD8 device, only the

Positive (+) and Negative (-) wires are to be connected to the touchpanel. Do not

connect the Shield (S) wires.

AUDIO Pinouts-Unbalanced

PIN # DESIGNATION DESCRIPTION

1 S Ground

2 R+ Right Input (Positive)

3 R- Right Ground

4 L+ Left Input (Positive)

5 L- Left Input Ground

6 S Ground

NOTE: Using two jumpers, connect R Shield to R - and L Shield to L - respectively

at the TPS-4000L Audio Input connector. Refer to the following diagram.

Wiring for Unbalanced Audio

Jumpers

NTSC/PAL INPUT

This port provides unbalanced composite and S-video input (using the two 2-position

mini-terminal block connectors) or balanced video input (using the 6-position mini-

terminal block connector) for video signals. Both sets of inputs support both NTSC

and PAL formats. Balanced video format is typically used when distributing video

via CAT 5 (i.e., from a Crestron CNX-PVID8x3 or 8x4). Unbalanced video is

typically used when distributing video via coaxial cable.

NOTE: Cable runs for balanced video should not exceed 500 feet (152.4 meters)

and cable runs for unbalanced video should not exceed 100 feet (30.5 meters). For

distances greater than these specified lengths use a distribution amplifier.

Operations Guide – DOC. 6301 10.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys® TPS-4000L • 17