Specifications

Crestron Isys

TPS-3100L 6.4” Lectern/Wall Mounted Touchpanel

NOTE: When sending balanced audio from a CNX-BIPAD8 or CNX-PVID device,

only the Positive (+) and Negative (-) wires are to be connected to the touchpanel.

Do not connect the Shield (S) wires.

AUDIO Pinouts-Unbalanced

PIN # DESIGNATION DESCRIPTION

1 S Ground

2 R+ Right Input (Positive)

3 R- Right Ground

4 L+ Left Input (Positive)

5 L- Left Input Ground

6 S Ground

NOTE: Using two jumpers, connect R Shield to R - and L Shield to L - respectively

at the TPS-3100L Audio Input connector. Refer to the following diagram.

Wiring for Unbalanced Audio

Jumpers

NTSC/PAL INPUT

This port provides unbalanced composite and S-video input (using a 2-position mini-

terminal block connectors) or balanced video input (using a 6-position mini-terminal

block connector) for video signals. Both sets of inputs support both NTSC and PAL

formats. Balanced video format is typically used when distributing video via CAT 5

(i.e., from a Crestron CNX-PVID8x3 or 8x4). Unbalanced video is typically used

when distributing video via coaxial cable.

NOTE: Cable runs for balanced video should not exceed 500 feet (152.4 meters)

and cable runs for unbalanced video should not exceed 100 feet (30.5 meters). For

distances greater than these specified lengths use a distribution amplifier.

Operations Guide – DOC. 6291 6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys® TPS-3100L • 17