Specifications

6.4 Inch Tilt Touchpanel Crestron Isys
®
TPS-3000
5. To verify communication, select Diagnostics | Establish Communications
(Find Rack). This should display a window that gives the COM port and
baud rate. If communication cannot be established, refer to the
“Troubleshooting Communications” section in the latest version of the
2-Series Control System Reference Guide (Doc. 6256) or the respective
Operations Guide for the control system.
Uploading a SIMPL Windows Program to a Control
System
The SIMPL Windows file can be uploaded to the control system using SIMPL
Windows or via the Crestron Viewport. A control system source file has the
extension .smw. A compiled SIMPL Windows file has the extension .spz for a
2-Series control system, .bin for CNX generation, and .csz for CNX generation with
SIMPL+.
Upload via SIMPL Windows
1. Start SIMPL Windows.
2. Select File | Open to view the “Open” window.
3. Navigate to the SIMPL Window file (.smw), and click Open.
4. Select Project | Transfer Program
Upload via Crestron Viewport
1. Verify that the procedure for “Communication Settings” that begins on page
32 has been performed.
2. As shown after this step, select File Transfer | Send Program
(alternatively, press Alt+P) from the Viewport menu.
File Transfer | Send Program Command
3. The “Send Program” window appears, as shown after this step. Click
Browse, locate the compiled file (.spz) and click Open. This will display
the program's header information and enable one or both of the What to
Send check boxes. If the program does not contain any SIMPL+ modules,
only the SIMPL Program check box will be enabled. If it does contain
SIMPL+ modules, then the SIMPL+ Program(s) check box will also be
enabled. Select one or both check boxes and then click Send Program to
begin the transfer.
NOTE: Refer to the respective Operations Guide for the control system for details
about the other fields shown on the “Send Program” window.
34 • 6.4 Inch Tilt Touchpanel: Crestron Isys
®
TPS-3000 Operations Guide – DOC. 6076A