Specifications

Crestron Quick Guide to Touchpanel Connections

Doc. 4903B

NET/VIDEO (To Panel)

This 10-pin RJ-45 connection mates with the TPS-3000, TPS-5000, or TPS-6000 touchpanel.

Refer to the descriptions and pinout table that follow this paragraph. The

10-pin net/video cable assembly to connect the touchpanel to the TPS-

IMPC is supplied. This port provides the Cresnet connection to the

touchpanel.

This port also provides composite or S-video input for the built-in video

card (with the purchase of a TPS-3000 or installation of the TPS-VID-1/2

in a TPS-5000 or TPS-6000 touchpanel).

CAUTION: It is possible to mistakenly insert the 8-pin audio cable into this port.

Consult the latest revision of the TPS-3000 Operations Guide (Doc. 6076) or TPS-VID-1/2 Operations &

Installation Guide (Doc. 6059) for details.

NET/VIDEO

PIN DESIGNATION DESCRIPTION

1 +24V Power (Network)

2 GND Ground (Network)

3 C + Chrominance (Positive) /Composite 2

4 C - Chrominance (Negative) /Composite 2

5 Y Data (Network)

6 Z Data (Network)

7 Y + Luminance (Positive) /Composite 1

8 Y - Luminance (Negative) /Composite 1

9 GND Ground (Network)

10 +24V Power (Network)

To determine the location of pin 1, hold the cable so that the end of the 10-pin RJ-45 connector is facing

away from you, with the clip side down and the copper side up.

The copper connector on the far left is pin 1.

CAUTION: The 10-pin RJ-45 net/video connector cable supplied by Crestron is a custom cable and is the only one that should

be used. The end of the cable has a metal shield that is required to protect the equipment. Using non-Crestron cables will

result in damage to the product.