Specifications

Crestron Quick Guide to Touchpanel Connections
Doc. 4903B 15
LAN
One 8-wire RJ-45 connector with two LED indicators:
The green LED indicates network speed
The yellow LED indicates Ethernet activity
This connector provides an Ethernet 10baseT/100baseTX, full
duplex, IEEE 802.3U compliant network connection.
PIN SIGNAL PIN SIGNAL
1 TX + 5 N/C
2 TX - 6 RC -
3 RC+ 7 N/C
4 N/C 8 N/C
NET
The four-pin 5 mm
detachable terminal block
provides communication
with and power from a
Cresnet control network.
Pins 24 and G provide 24
VDC and ground.
Pins Y and Z provide
communications (data).
Cresnet
®
Power Usage
Not including TPMC-CH-IMC (1.0W)
TPS-12G-QM: 50 Watts (2.08 Amps @ 24 Volts DC)
TPS-15G-QM: 75 Watts (3.13 Amps @ 24 Volts DC)
TPS-12G-QM: PW-2420RU
TPS-15G-QM: must use Cresnet power supply
PC CARD
Two Type II PCMCIA Card slots used for memory
expansion up to 4GB or more, VT Pro-e project uploads,
or installation of a wireless network card.
A cover is secured over the slots to protect the
electronics. Use a #1 Phillips screwdriver to remove the
cover. The plate can be flipped and secured if only one
slot needs to be accessed.
CAUTION: PCMCIA cards are installed face down.