Specifications

Tilt Touchpanels Crestron Isys

TPS-12/15/17

Toolbox Functions Menu – Specific to TPS-12/15/17

NOTE: The list of functions depends on the type of device.

TCP/IP Communication

This section explains how to configure a TPS-12/15/17 to communicate over

Ethernet using TCP/IP. These procedures assume that the touchpanel has been

powered up and connected properly.

PC-to-touchpanel communications can be implemented over TCP/IP as shown in the

following diagram. TCP/IP is the fastest method of communicating between the PC

and the touchpanel.

Typical Connection Diagram when Uploading a Touchpanel Project or Firmware to the

Touchpanel via TCP/IP

1. To establish TCP/IP communications with the touchpanel, a serial

connection must be established between the PC and touchpanel. Refer to

“Indirect Serial Communication” on page 43 or “Direct Serial Connection”

on page 46 for instructions.

2. While connected to the touchpanel, select Functions | Ethernet

Addressing. The current IP address, IP mask and default router are

displayed.

¥ Tilt Touchpanels: TPS-12/15/17 Operations Guide – DOC. 6375