Specifications

Tilt Touchpanels Crestron Isys

TPS-12/15/17

Indirect Serial Communications Setup Connections

1. Ensure that all devices are connected to the control processor and the

control processor is connected via serial cable to the PC.

2. Open Crestron Toolbox and click Tools | Manage Address Book to display

a list of available devices. Select Serial on COM1 as the connection type.

Serial on COM1 is an entry in the DefaultAddressBook that is included

with Crestron Toolbox.

The PC communication settings specified here should match the protocol

that the control processor expects. The usual settings are as follows:

• Port = COM 1 through COM 8. Select the correct COM port on the

PC.

• Baud rate = Auto-Detect.

• Parity = None.

• Number of data bits = 8.

• Number of stop bits = 1.

• Hardware handshaking (RTS/CTS) enabled.

• Software handshaking (XON/XOFF) not enabled.

“Address Book” Window – Serial Setup

¥ Tilt Touchpanels: TPS-12/15/17 Operations Guide – DOC. 6375