Specifications

Crestron Isys
®
TPS-12/15/17 Tilt Touchpanels
AUDIO I/O
This 8-pin RJ-45 connector provides connectivity to the CNX-BIPAD or with the
TPMC-CH-IMC interface module. This port uses Crestron Certified Wiring and
provides audio input to the touchpanel and microphone output from the touchpanel.
A description of the pinouts is shown in the following table.
CAUTION: Only use the TPMC-CH-IMC Interface Module when connecting this
port. Use of other “IMC” products could damage the panel.
Audio In/Out Pin Assignments
PIN WIRE COLORS (568B) AUDIO I/O
1 WHITE/ORANGE + Mic Left Out
2 ORANGE - Mic Left Out
3 WHITE/GREEN + Mic Right Out
4 BLUE + Audio Left In
5 WHITE/BLUE - Audio Left In
6 GREEN - Mic Right Out
7 WHITE/BROWN + Audio Right In
8 BROWN - Audio Right In
Pushbuttons
Five pushbuttons are located on the top of the base as shown in the following
diagram. The leftmost button is recessed and is a hard reset used to reboot the
touchpanel. The other four buttons are programmable. Refer to page 34 for hard
button programming information.
TPS-12/15/17 Pushbuttons
TPMC-CH-IMC Interface Module
For networks without CAT5 audio and video, the TPMC-CH-IMC is included to
convert unbalanced video sent over coax cable and balanced/unbalanced audio sent
over shielded, twisted-pair wiring to Crestron Certified Wiring for connection to the
touchpanels.
NOTE: The TPMC-CH-IMC is not for use with QuickMedia.
Operations Guide – DOC. 6375 Tilt Touchpanels: TPS-12/15/17 ¥
13