Specifications

Crestron Isys

TPS-12/15/17 Tilt Touchpanels

LAN

One 8-wire RJ-45 connector with two LED indicators (green LED indicates link

status, yellow LED indicates Ethernet activity). This connector provides an Ethernet

10baseT /100baseTX, full duplex, TCP/IP, UDP/IP, CIP, DHCP, IEEE 802.3U

compliant network connection.

Network Connector Pinout

PIN SIGNALS

1 TX +

2 TX -

3 RC+

4 N/C

5 N/C

6 RC -

7 N/C

8 N/C

NET

The four-pin 5 mm detachable terminal block provides communication with and

power from a Cresnet control network. For additional details, refer to “Network

Wiring” on page 14. A cable for this connection is provided with the touchpanel.

Pins 24 and G provide 24 VDC and ground.

Pins Y and Z provide communications (data).

USB

One Universal Serial Bus (USB) “B” connector provides a communications link.

USB is a connectivity specification developed by the USB Implementers Forum

that provides a single, simple, standardized way to connect devices to a computer.

USB shielded cables contain two wires for power +5 volts (red) and ground

(brown) and a twisted pair of wires (yellow and blue) that carry data.

USB Type B Connector Pinout

PIN DESCRIPTION

1 +5 VDC

2 Data -

3 Data +

4 Ground

NOTE: This connector is reserved for

future applications.

PHONE

Connect this standard mini phone jack (12 mW, 32 ohm load) to the plug of a 3.5

mm external headphone set plug (not supplied). Plugging in the headphone cuts off

the speakers.

MEMORY EXPANSION

The onboard memory may be enhanced with the addition of a Type II compact flash

memory (up to 160 MB).

The flash memory slot is accessible on the rear panel of the unit.

Operations Guide – DOC. 6375 Tilt Touchpanels: TPS-12/15/17 ¥