Installation guide

4.3” Designer Touch Screen Crestron TPMC-4SMD
Touch Test Screen
During touch screen calibration, a crosshair appears at the center of the screen.
Touch the center of the crosshair, which then moves to the upper left part of the
screen. Touch the center of the crosshair and it moves to another part of the screen.
Continue touching the center of the crosshair at each new location until calibration is
complete.
NOTE: When touching the screen during calibration, be as accurate as possible.
Use the tip of a capped pen or the eraser end of a pencil.
From the “Diagnostics” menu, touch Sensor Test to display the “Diagnostics –
Sensor Tests” screen, shown in the illustration below.
“Diagnostics – Sensor Tests” Screen
If contact sensors are connected to the TPMC-4SMD, the respective indicator
changes from Inactive to Active as appropriate for each sensor’s activity. Similarly,
the TPMC-4SMD’s own proximity sensor’s indicator changes from Inactive to
Active when the TPMC-4SMD senses motion in front of the unit. Use the Sensor
Strength controls to adjust proximity sensor sensitivity. Touch Back to return to the
“Diagnostics” menu.
On “Diagnostics” menu, touch Mic Test to perform a test of the TPMC-4SMD’s
built-in microphone. The button label changes to RECORDING/PLAYBACK and
the screen displays a Mic test in progress message, as shown in the illustration
below.
20 • 4.3” Designer Touch Screen: TPMC-4SMD Operations & Installation Guide – DOC. 7027E