Installation guide

Crestron TPMC-4SMD 4.3” Designer Touch Screen
Confirm IP Table Entry Removal Screen
Touch OK to confirm the removal or touch CANCEL to cancel the removal. The
display returns to the “Control System Interface” menu (refer to the illustration at the
bottom of page 13). From the “Control System Interface” menu, touch Back to
return to the “Ethernet Setup” menu.
On the TPMC-4SMD, DHCP is enabled by default. To switch to a static IP address,
touch IP Address Settings on the “Ethernet Setup” menu, to access the “Edit IP
Address Settings” screen. (Touch Back to return to the “Panel Setup Options”
menu.)
“Edit IP Address Settings” Screen
Touch the Enabled/Disabled button to toggle between DHCP enabled and disabled.
Then touch the button for the Static IP Address, Static Subnet Mask or Static Default
gateway desired. The on-screen keyboard opens. After entering the addresses, touch
OK to add the entries or CANCEL to cancel them.
On the “Edit IP Address Settings” screen, touch Edit DNS Servers to enter the
screen for editing these addresses, shown in the illustration below.
Touch Save to keep the new setting or Cancel to cancel it.
Operations & Installation Guide – DOC. 7027E 4.3” Designer Touch Screen: TPMC-4SMD • 15