Installation guide

4.3” Designer Touch Screen Crestron TPMC-4SMD
Touch the IP Address / Hostname button. The on-screen keyboard opens, as shown
in the illustration below.
On-Screen Keyboard
Touch CLEAR to remove any previous entry. Then enter the address required.
Touch OK to accept the entry or CANCEL to cancel the entry. This hides the on-
screen keyboard and returns the display to the Edit Control System Settings” screen.
On the “Edit Control System Settings” screen, touch Save to keep the change or
Cancel to cancel the change and return to the “Control System Interface” menu.
To edit the port, CIP ID or Device ID, touch the appropriate button. Touching the
Port (41794) button opens the numeric keypad. Touching the CIP ID or Device ID
buttons opens a hex keypad, shown in the illustration that follows.
Hex Keypad
Touch CLEAR to remove any previous entry. Then enter the ID required. Touch
OK to accept the entry or CANCEL to cancel the entry. This hides the hex keypad
and returns the display to the “Edit Control System Settings screen.
On the “Edit Control System Settings” screen, touch Save to keep the changes or
Cancel to cancel the changes and return to the “Control System Interface” menu.
From the “Control System Interface” menu, to edit or remove an IP entry, first touch
the appropriate button containing the entry. Then touch Edit IP or Remove IP as
appropriate. Editing an entry displays the “Edit Control System Settings” screen
(refer to the middle illustration on page 13). Removing an entry displays a message
saying Please Confirm IP Table Entry Removal By Pressing the OK Button, as
shown in the illustration below.
14 4.3” Designer Touch Screen: TPMC-4SMD Operations & Installation Guide DOC. 7027E